Photo: Fred Logue · CC BY-SA 2.0Some of Julianstown’s homes have high radon: an estimated 9.1%, above the reference level
Julianstown has no Hazard risk Grade: Irish places under 1,000 residents aren’t graded. The figures below are still its own.
What stands out about Julianstown’s hazards
From the EPA’s radon map, Geological Survey Ireland’s landslide map, the OPW’s flood relief schemes and our estimate of low-lying homes, below.
What Julianstown faces
Each hazard against its own yardstick; meters run from low to high on that yardstick.
Low-lying homes
Radon
Landslides
Bathing water
Ground heights
Julianstown has no Hazard risk Grade
Each figure is placed among Irish towns as the grade would place it, without a letter.
Less sure: The low-lying figure is our estimate from ground heights and the river map, not an official flood map. It can show a town is low-lying; it can’t show a town is safe. No LiDAR here: the heights come from a 30 m satellite model, which reads roofs and trees as ground, so this town’s figure isn’t counted.
How many of Julianstown’s homes stand low isn’t measured
Low-lying homes, a TownRatings estimate from OPW and Geological Survey Ireland LiDAR ground heights and the EPA’s river map: not an official flood map.
Flooding isn’t measured in Julianstown: no LiDAR survey covers its homes, and the measure needs 80% of them, so flood isn’t counted for or against it. That doesn’t mean it doesn’t flood.
A rougher estimate, mostly from a 30 m satellite model, puts about 3.9% of homes low beside the River Nanny. That model reads roofs and trees as ground, so it misses low homes more often than it invents them.
The River Nanny at Duleek (downstream) peaked at 3.52 m in November 2000
Each winter’s highest level (October to September) at the OPW’s Duleek (downstream) gauge, 7.7 km from Julianstown on the same river, since 1979, in metres above the gauge’s zero. Nine days in ten it runs between 0.64 m and 1.39 m.
- 6 November 20003.52 m
- 26 August 19863.48 m
- 7 October 19933.27 m
- 14 November 20023.24 m
- 5 January 19993.23 m
- 12 June 19933.21 m
Since 1979 the River Nanny has run above its usual top on 1,039 days, most of them in the winters of 2025–26 and 2023–24.
Measured by its highest day, last winter (2025–26) was the 7th-highest of the 36 on record here.
Source: OPW Hydro-Data (waterlevel.ie/hydro-data), Duleek (downstream) gauge (station 08011): daily maximum and mean levels, inspected and provisional data. The usual range is the 5th to 95th percentile of daily means, worked out by TownRatings. Live levels are on waterlevel.ie.
Weather and flood warnings for Julianstown
Where to see the warnings in force, and what this page can’t count.
Met Éireann issues yellow, orange and red warnings for rain, wind and coastal flooding county by county; Julianstown is covered by County Meath’s.
| Warning | What Met Éireann means by it |
|---|---|
| Yellow | Weather that isn’t unusual but can be dangerous in places: be aware. |
| Orange | Infrequent, dangerous weather that can put people and property at risk: be prepared. |
| Red | Rare, extremely dangerous weather: take action to protect yourself and your property. |
Met Éireann doesn’t publish an open archive of past warnings, so how often warnings have covered Julianstown can’t be counted here.
No OPW flood relief scheme protects Julianstown
The Office of Public Works’ completed flood relief schemes and the areas each one benefits (OPW open data, CC BY 4.0).
None of the OPW’s completed flood relief schemes has a benefiting area that takes in Julianstown’s homes. The OPW builds schemes where the risk to homes is greatest, so most towns have none.
In County Meath, OPW schemes protect parts of 4 other places, including Laytown-Bettystown-Mornington-Donacarney, Dunboyne, Duleek, Clonee.
| Town | Scheme | Designed for | Homes behind it | Away |
|---|---|---|---|---|
| Laytown-Bettystown-Mornington-Donacarney Meath | Mornington Flood Relief Scheme | 1 in 100 | 9.1% | 4.2 km |
| Duleek Meath | Duleek Flood Relief Scheme | 1 in 100 | 12% | 9.4 km |
| Mulhuddart Dublin | River Tolka (Fingal) Flood Relief Scheme | 1 in 100 | under 0.1% | 30 km |
| Dunboyne Meath | River Tolka (Clonee and Dunboyne) Scheme | 1 in 100 | 14% | 30 km |
| Clonee Meath | River Tolka (Clonee and Dunboyne) Scheme | 1 in 100 | 57% | 31 km |
| Clonsilla Dublin | River Tolka (Clonee and Dunboyne) Scheme | 1 in 100 | 0.5% | 32 km |
No home in Julianstown stands on landslide-prone ground
Geological Survey Ireland’s landslide susceptibility map (1:50,000), read at every home.
Homes on ground rated high or moderately high
Julianstown is among the 64% of Irish towns with no home on such ground.
GSI rates ground from low to high by its slope, soil and rock. Most Irish landslides are on steep upland slopes and peat after heavy rain; a town on flat ground has almost none.
High means the ground could slide under the right conditions, such as days of heavy rain on a steep, wet slope; it isn’t a forecast that it will.
GSI landslide susceptibility, high and moderately high classes, share of the town’s homes on mapped ground (CC BY 4.0).
An estimated 9.1% of Julianstown’s homes are above the radon reference level
The EPA’s radon map: for each 10 km square, the estimated share of homes above the national reference level of 200 Bq/m³.
A square where 10% or more of homes are estimated above the reference level is a High Radon Area; 27% of Julianstown’s homes are in one. The map is an estimate by area: two neighbouring houses can differ a lot.
A test is the only way to know a home’s level: two detectors, left for three months in a living room and a bedroom.
EPA radon map of Ireland (10 km grid), averaged over the town’s homes (CC BY 4.0).
One EPA-licensed site within 5 km of Julianstown’s centre, none inside it
Factories, farms, power plants and waste sites that hold an EPA licence for their emissions, in Julianstown and around its centre.
| Site | Licence and activity | Away |
|---|---|---|
| Murphy Concrete Manufacturing Limited | Waste licence | 2.2 km |
| Tirlán Limited | Industrial Emissions licence · food and drink | 5.9 km |
| Drogheda Port Company (Tom Roes Point Port Terminal) | Industrial Emissions licence · waste | 6.5 km |
| Premier Periclase Limited | Industrial Emissions licence · cement and lime | 6.8 km |
| Boylan Print Limited | IPC licence | 7.4 km |
| Irish Cement Limited (Platin) | Industrial Emissions licence · cement and lime | 7.5 km |
| Indaver Ireland Limited (Duleek) | Industrial Emissions licence · waste | 7.6 km |
| Clashford Recovery Facilities LTD | Waste licence | 8.2 km |
| Activity | Sites |
|---|---|
| Waste | 8 |
| Food and drink | 2 |
| Cement and lime | 2 |
| Not classed in the register | 2 |
| Energy | 1 |
Within 5 km: one waste facility.
An EPA licence sets what a site may release to air, water and land; it doesn’t mark the site as an accident hazard.
Sites holding dangerous substances in bulk come under the COMAH (Seveso) rules, but the HSA’s list of them has no open licence, so upper- and lower-tier sites aren’t counted here.
Source: EPA registers of Industrial Emissions, IPC and waste licences, sites licensed on 31 October 2026; distances in a straight line from the town’s centre.
Hazards in the places around Julianstown
Low-lying homes, radon and landslide ground, town by town.
| Town | Low-lying | Radon | Landslides |
|---|---|---|---|
| Julianstown | – | 9.1% | 0% |
| Stamullen 3,720 · 4.0 km | – | 32% | 0% |
| Laytown-Bettystown-Mornington-Donacarney 15,642 · 4.2 km | – | 0.4% | 0% |
| Drogheda 44,135 · 7.1 km | 1.6% | 1.1% | under 0.1% |
| Balbriggan 24,322 · 8.3 km | – | 22% | 0% |
| Duleek 4,899 · 9.4 km | – | 10% | 0% |
| Balrothery 2,282 · 11 km | – | 5.1% | 0% |
None of the measured places around Julianstown has many homes standing low by big water.
A dash under Low-lying: not measured there (too few homes with detailed ground heights), not none.
Get ready for what Julianstown faces
What to do, and what to ask before you move.
- Never walk or drive through floodwater: 30 cm of moving water can float a car.
- Move valuables, papers and medicines upstairs.
- Turn off gas, electricity and water if you’re told to.
- Test over three months, in a living room and a bedroom.
- Above 200 Bq/m³, a small sump and fan usually fixes it.
- The EPA sells radon test kits at radon.ie and lists registered contractors who fix high readings.
- Bring in or tie down bins, trampolines and anything the wind can lift.
- Keep away from coastal paths and piers while an orange or red warning is in force.
- Charge phones and keep a torch: fallen lines are the commonest storm damage.
- After the storm, report a fallen line to ESB Networks and keep well clear of it.
- Ask whether the home has ever flooded, and get a buildings insurance quote before you commit: flood cover isn’t always offered.
- Ask the seller or landlord for a radon test result, or test in your first months there.
- Check the address on floodinfo.ie: the OPW’s flood maps and its record of past floods.
What this data can and can’t tell you
- An estimate, not a flood map. Low-lying homes is a TownRatings modelling step: each home’s ground height from LiDAR, against the level of the nearest big river (Strahler order 5 or more), lake or estuary within 1 km, or the sea within 2 km. A home within 5 m of the water’s level, or below 4 m near the sea, counts.
- Flood counts only one way. A high share of low-lying homes lowers the Hazard risk Grade; a low share never raises it, because defences, small streams, culverts, groundwater and flash floods don’t show in ground heights. Below the national median a town scores as the median.
- Defences aren’t counted. Flood defences aren’t taken off: the OPW scheme that protects the most homes is shown instead, with its design standard.
- Measured where the heights are detailed. A town is measured, and counted, only where 80% of its homes stand on LiDAR heights. Elsewhere the page says flooding isn’t measured, never that the town is dry.
- Radon is an estimate by area. The EPA’s radon map gives the estimated share of homes above 200 Bq/m³ for each 10 km square, averaged here over the town’s homes. It says where to test, not what one house holds.
- The sea is measured by height. Homes count as low by the sea when their ground is under 4 m and within 2 km of coastal or estuary water; waves, surges and erosion aren’t modelled.
- Landslide ground is a map of where slides could start. GSI’s susceptibility map rates the ground itself; it doesn’t record past slides or say when one will happen.
- Bathing water is rated season by season. The EPA classes each identified bathing water from four seasons of samples; a rating says how clean the water has been, not how safe it is to swim.
- One town, many streets. Risk is street by street. Check a specific address on floodinfo.ie before you buy or rent.
Check any address against the OPW’s official flood maps on floodinfo.ie
Questions about flooding and hazards in Julianstown
Does Julianstown flood?
For a single address, the OPW’s official flood maps and past floods are on floodinfo.ie.
Is radon a problem in Julianstown?
The EPA’s map estimates that about 9.1% of homes around Julianstown are above the radon reference level of 200 Bq/m³: a higher share than in 77% of Irish towns. 27% of its homes are in a High Radon Area. The only way to know a house is a three-month test.
Is Julianstown at risk of landslides?
No home in Julianstown stands on ground rated high or moderately high for landslides.
How does Julianstown compare with the places around it?
Radon estimates around Julianstown run from 0.4% in Laytown-Bettystown-Mornington-Donacarney to 32% in Stamullen; Julianstown’s own is 9.1%.
Where is the nearest bathing water to Julianstown?
Laytown/Bettystown, 4.7 km away, was rated excellent for the 2025 season; 5 identified bathing waters lie within 15 km.
Flood: TownRatings’ estimate from ground heights, not an official flood map. Contains Irish Public Sector Data (Geological Survey Ireland, the Office of Public Works and the EPA) licensed under CC BY 4.0; Copernicus DEM © DLR e.V. and © Airbus, provided under COPERNICUS by the EU and ESA; © OpenStreetMap contributors. Radon and bathing water: EPA (CC BY 4.0). Landslide susceptibility: Geological Survey Ireland (CC BY 4.0).
Sources: low-lying homes: TownRatings’ estimate from GSI and OPW LiDAR, Copernicus GLO-30 and the EPA river network · radon: EPA radon map · landslides: GSI landslide susceptibility · bathing water: EPA bathing water quality · river levels: OPW Hydro-Data (waterlevel.ie/hydro-data) · industrial sites: EPA licence registers. Under Creative Commons Attribution 4.0 (CC BY 4.0).
Contains Central Statistics Office (CSO) data, Census 2022, and Tailte Éireann boundaries (CSO Urban Areas, Small Areas, local electoral areas, constituencies), under Creative Commons Attribution 4.0 (CC BY 4.0).