Photo: Zairon · CC BY 4.0Radon reaches above the reference level in about 5% of Milltown’s homes
Steady ground does most for Milltown’s grade: with 0% of homes on landslide-prone ground, it grades B. Flood counts only against a town, so its share of low-lying homes earns it no credit: radon and landslide ground set the grade.
What stands out about Milltown’s hazards
From the EPA’s radon map, Geological Survey Ireland’s landslide map, the OPW’s flood relief schemes and our estimate of low-lying homes, below.
What Milltown faces
Each hazard against its own yardstick; meters run from low to high on that yardstick.
Low-lying homes
Radon
Landslides
Ground heights
Hazard risk in Milltown: B
Radon, landslide ground and low-lying homes, each against Irish towns, then averaged.
Each figure is placed among Irish towns of 1,000 or more people; the grade averages the three, so a better place on each is a better grade.
Flood counts only against a town, never for it: Milltown’s share of low-lying homes would have raised its grade, so it isn’t counted, and radon and landslide ground set it.
Less sure: The low-lying figure is our estimate from ground heights and the river map, not an official flood map. It can show a town is low-lying; it can’t show a town is safe.
Few of Milltown’s homes stand low by a big river, lake or the sea
Low-lying homes, a TownRatings estimate from OPW and Geological Survey Ireland LiDAR ground heights and the EPA’s river map: not an official flood map. Smaller streams, drains and groundwater aren’t in this measure, so a low figure doesn’t mean a town never floods.
Share of each town’s homes standing low by big water, for the towns measured in detail. 43% have none; Milltown has more than 21% of them.
Low-lying homes across County Kerry’s towns · 4 towns measured in detail
Homes: OpenStreetMap buildings of 30 m² or more, not tagged as non-residential, in the town’s Census 2022 Small Areas. Heights: GSI Open Topographic Data LiDAR (OPW, TII and GSI surveys). Water: EPA river network (rivers of Strahler order 5 or more), lakes, estuaries and coastal waters.
Weather and flood warnings for Milltown
Where to see the warnings in force, and what this page can’t count.
Met Éireann issues yellow, orange and red warnings for rain, wind and coastal flooding county by county; Milltown is covered by County Kerry’s.
| Warning | What Met Éireann means by it |
|---|---|
| Yellow | Weather that isn’t unusual but can be dangerous in places: be aware. |
| Orange | Infrequent, dangerous weather that can put people and property at risk: be prepared. |
| Red | Rare, extremely dangerous weather: take action to protect yourself and your property. |
Met Éireann doesn’t publish an open archive of past warnings, so how often warnings have covered Milltown can’t be counted here.
No OPW flood relief scheme protects Milltown
The Office of Public Works’ completed flood relief schemes and the areas each one benefits (OPW open data, CC BY 4.0).
None of the OPW’s completed flood relief schemes has a benefiting area that takes in Milltown’s homes. The OPW builds schemes where the risk to homes is greatest, so most towns have none.
No other place across County Kerry has an OPW flood relief scheme either.
| Town | Scheme | Designed for | Homes behind it | Away |
|---|---|---|---|---|
| Dunmanway Cork | Dunmanway Flood Relief Scheme | 1 in 100 | 14% | 62 km |
| Mallow Cork | Mallow South & West Flood Relief Scheme | 1 in 100 | 2.6% | 73 km |
| Ennis Clare | Ennis (Upper) Flood Relief Scheme | 1 in 100 | 3.5% | 92 km |
| Fermoy Cork | Fermoy South Flood Relief Scheme | 1 in 100 | 6.3% | 98 km |
| Annacotty Limerick | Mulkear River (Ballymackeogh) Flood Relief Scheme | 1 in 10 | 1.1% | 99 km |
| Gort Galway | Gort River (Bridge Street) Drainage Scheme | 1 in 100 | 0.9% | 119 km |
No home in Milltown stands on landslide-prone ground
Geological Survey Ireland’s landslide susceptibility map (1:50,000), read at every home.
Homes on ground rated high or moderately high
Milltown is among the 64% of Irish towns with no home on such ground.
GSI rates ground from low to high by its slope, soil and rock. Most Irish landslides are on steep upland slopes and peat after heavy rain; a town on flat ground has almost none.
High means the ground could slide under the right conditions, such as days of heavy rain on a steep, wet slope; it isn’t a forecast that it will.
GSI landslide susceptibility, high and moderately high classes, share of the town’s homes on mapped ground (CC BY 4.0).
An estimated 5% of Milltown’s homes are above the radon reference level
The EPA’s radon map: for each 10 km square, the estimated share of homes above the national reference level of 200 Bq/m³.
A square where 10% or more of homes are estimated above the reference level is a High Radon Area; 0% of Milltown’s homes are in one. The map is an estimate by area: two neighbouring houses can differ a lot.
A test is the only way to know a home’s level: two detectors, left for three months in a living room and a bedroom.
EPA radon map of Ireland (10 km grid), averaged over the town’s homes (CC BY 4.0).
2 EPA-licensed sites within 5 km of Milltown’s centre, none inside it
Factories, farms, power plants and waste sites that hold an EPA licence for their emissions, in Milltown and around its centre.
| Site | Licence and activity | Away |
|---|---|---|
| Milltown Transfer Station | Waste licence | 1.8 km |
| Kilfilum Limited | Industrial Emissions licence · intensive farming | 3.0 km |
| Temmler Ireland Limited | IPC licence | 5.2 km |
| Activity | Sites |
|---|---|
| Waste | 1 |
| Intensive farming | 1 |
| Not classed in the register | 1 |
Within 5 km: one under an Industrial Emissions licence and one waste facility.
An EPA licence sets what a site may release to air, water and land; it doesn’t mark the site as an accident hazard.
Sites holding dangerous substances in bulk come under the COMAH (Seveso) rules, but the HSA’s list of them has no open licence, so upper- and lower-tier sites aren’t counted here.
Source: EPA registers of Industrial Emissions, IPC and waste licences, sites licensed on 31 October 2026; distances in a straight line from the town’s centre.
Hazards in the places around Milltown
Low-lying homes, radon and landslide ground, town by town.
| Town | Low-lying | Radon | Landslides |
|---|---|---|---|
| Milltown | 0% | 5% | 0% |
| Killorglin 2,163 · 6.7 km | 3.7% | 0.9% | 0% |
| Tralee 26,079 · 14 km | 21% | 26% | 0% |
| Killarney 14,412 · 17 km | 22% | 3.6% | under 0.1% |
Of the places around Milltown, Killarney has the most homes standing low by big water (22%), 17 km away.
A dash under Low-lying: not measured there (too few homes with detailed ground heights), not none.
Get ready for what Milltown faces
What to do, and what to ask before you move.
- Never walk or drive through floodwater: 30 cm of moving water can float a car.
- Move valuables, papers and medicines upstairs.
- Turn off gas, electricity and water if you’re told to.
- Test over three months, in a living room and a bedroom.
- Above 200 Bq/m³, a small sump and fan usually fixes it.
- The EPA sells radon test kits at radon.ie and lists registered contractors who fix high readings.
- Bring in or tie down bins, trampolines and anything the wind can lift.
- Keep away from coastal paths and piers while an orange or red warning is in force.
- Charge phones and keep a torch: fallen lines are the commonest storm damage.
- After the storm, report a fallen line to ESB Networks and keep well clear of it.
- Ask whether the home has ever flooded, and get a buildings insurance quote before you commit: flood cover isn’t always offered.
- Ask the seller or landlord for a radon test result, or test in your first months there.
- Check the address on floodinfo.ie: the OPW’s flood maps and its record of past floods.
What this data can and can’t tell you
- An estimate, not a flood map. Low-lying homes is a TownRatings modelling step: each home’s ground height from LiDAR, against the level of the nearest big river (Strahler order 5 or more), lake or estuary within 1 km, or the sea within 2 km. A home within 5 m of the water’s level, or below 4 m near the sea, counts.
- Flood counts only one way. A high share of low-lying homes lowers the Hazard risk Grade; a low share never raises it, because defences, small streams, culverts, groundwater and flash floods don’t show in ground heights. Below the national median a town scores as the median.
- Defences aren’t counted. Flood defences aren’t taken off: the OPW scheme that protects the most homes is shown instead, with its design standard.
- Measured where the heights are detailed. A town is measured, and counted, only where 80% of its homes stand on LiDAR heights. Elsewhere the page says flooding isn’t measured, never that the town is dry.
- Radon is an estimate by area. The EPA’s radon map gives the estimated share of homes above 200 Bq/m³ for each 10 km square, averaged here over the town’s homes. It says where to test, not what one house holds.
- The sea is measured by height. Homes count as low by the sea when their ground is under 4 m and within 2 km of coastal or estuary water; waves, surges and erosion aren’t modelled.
- Landslide ground is a map of where slides could start. GSI’s susceptibility map rates the ground itself; it doesn’t record past slides or say when one will happen.
- Bathing water is rated season by season. The EPA classes each identified bathing water from four seasons of samples; a rating says how clean the water has been, not how safe it is to swim.
- One town, many streets. Risk is street by street. Check a specific address on floodinfo.ie before you buy or rent.
Check any address against the OPW’s official flood maps on floodinfo.ie
Questions about flooding and hazards in Milltown
Does Milltown flood?
Smaller streams, drains and groundwater aren’t in that measure, so it doesn’t mean the town never floods. For a single address, the OPW’s official flood maps and past floods are on floodinfo.ie.
Is radon a problem in Milltown?
The EPA’s map estimates that about 5% of homes around Milltown are above the radon reference level of 200 Bq/m³: a higher share than in 54% of Irish towns. 0% of its homes are in a High Radon Area. The only way to know a house is a three-month test.
Is Milltown at risk of landslides?
No home in Milltown stands on ground rated high or moderately high for landslides.
Is Milltown at risk from the sea?
None of Milltown’s homes stands below 4 m within 2 km of the sea, so the sea plays no part in its share of low-lying homes; 0% stand low by rivers, lakes and estuaries.
How does Milltown compare with the places around it?
Radon estimates around Milltown run from 0.9% in Killorglin to 26% in Tralee; Milltown’s own is 5%. Among the places measured in detail, Killarney has the largest share of homes standing low (22%).
How is Milltown’s Hazard risk Grade worked out?
Milltown grades B: radon, landslide ground and low-lying homes are each placed among Irish towns, and the grade averages them.
Flood: TownRatings’ estimate from ground heights, not an official flood map. Contains Irish Public Sector Data (Geological Survey Ireland, the Office of Public Works and the EPA) licensed under CC BY 4.0; Copernicus DEM © DLR e.V. and © Airbus, provided under COPERNICUS by the EU and ESA; © OpenStreetMap contributors. Radon and bathing water: EPA (CC BY 4.0). Landslide susceptibility: Geological Survey Ireland (CC BY 4.0).
Sources: low-lying homes: TownRatings’ estimate from GSI and OPW LiDAR, Copernicus GLO-30 and the EPA river network · radon: EPA radon map · landslides: GSI landslide susceptibility · industrial sites: EPA licence registers · the grade: TownRatings, from these figures. Under Creative Commons Attribution 4.0 (CC BY 4.0).
Contains Central Statistics Office (CSO) data, Census 2022, and Tailte Éireann boundaries (CSO Urban Areas, Small Areas, local electoral areas, constituencies), under Creative Commons Attribution 4.0 (CC BY 4.0).